INN3837	LM-2 Single Sensor basic kit.	£225
INN3806	LM-2 Single Sensor Full Kit	£282.60
INN3807	LM-2 Duo (Twin Sensor) Kit	£477.86
INN3811	Innovate LM-2 Analogue Cable	£17.86
INN3812	Innovate LM-2 Serial Patch Cable MTS	£9.11
INN3813	Innovate LM-2 USB Cable	£4.29
INN3828	Innovate LM-2 18 Ft Sensor Extension Cable For The LM-2 Only	£49.29
INN3814	Innovate LM-2 Window Mount	£35.00

Prices are excluding VAT

The LM-2 combines an air/fuel meter, a full function 32-channel datalogger, and powerful software to deliver a complete tuning workshop for less than the cost of one dyno day. Whether you have a piggy-back fuel controller, race carb, aftermarket ECU, OBD-II tuning software, or a flash/chip programmer, an LM-2 is the measurement tool you need to dial in maximum HP.

The meter’s digital signal processing technology provides data on exactly how rich or lean an engine is running at any load. The LM-2’s self-calibrating circuitry also compensates for changes in temperature, altitude and sensor condition.

• Innovate “Direct Digital” Wideband Measurement Circuit
• Single or Dual Channel Version Available
• ODB-II Scan Tool – read/clear DTCs and log up to 32 channels of CAN OBD-II Data
• Log directly to SD card(Included)
• Playback log data on screen and/or with powerful analysis software LogWorks 3.0
• High contrast graphics LCD
• Built-in RPM converter( inductive clamp or direct frequency)
• 4 fully differential analog inputs
• 2 configurable linear analog outputs
• Innovate MTS serial IN and OUT
• USB connection to your PC

The LM-2 also features two fully programmable linear analog outputs to connect to analog gauges, dyno computers, ECUs, piggyback controllers, and other devices with analog inputs. Analog output 1 comes setup from the factory ready for narrowband simulation; analog output 2 is configured as 0 volt = 7.35 AFR and 5 volts = 22.39 AFR. With the provided LM Programmer software these analog outputs may also be configured by the user.

The LM-2 is available in two different kit configurations:

The LM-2 Kit (Single Wideband O2) includes the LM-2 meter, Bosch wide-band oxygen sensor, 10 ft sensor cable, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, weld-in bung and plug, LogWorks software CD, and quick-start guide. Carrying Case also included

The LM-2 Duo Kit (Dual Wideband O2) includes the LM-2 meter, (2) Bosch wide-band oxygen sensors, (2) 10 ft sensor cables, cigarette-lighter power adapter, analog in/out cable, ODB-II/CAN interface cable, SD memory card, USB cable for PC connection, (2) weld-in bung and plug kits, LogWorks software CD, and quick-start guide. Carrying Case also included!